TESAWQ

TESAWQ - car mirror camera

The car mirror camera contains two cameras (front / back)  1080p HD records at 30fps in the front  And VGA on the back.  The quality of low-light videos is average for a camera in this price range.  Resolution can also be set to 720p 30fps.    Water resistant rear camera   It comes with a VGA (480p) 30fps rear camera and is IP68 water and dust resistant.  It contains a 6-meter cable that connects to the front camera   The rear camera can be connected as well as the reverse light power.  The four LEDs will then turn on when the vehicle is put into reverse and the entire rear camera image will appear on the LCD screen.  This makes the camera ideal as a parking aid.   The camera can be easily placed over your existing rear view mirror and tightened using the provided rubber straps.   parking mode   It has two kinds of parking modes that have to be activated manually.  Note that for these functions to work properly, it must be powered on using the Hardwire Kit (see Accessories).   a movement   Activate the Motion Detection function  in the menu and the camera will remain in standby mode.  When motion is detected, it will start recording for 30 seconds and then switch to standby mode again.  Please note that this is a different type of recording and is best turned on only while parking and off during normal driving.   When standby mode is activated and the camera is turned off, it will turn on and start recording when vibration is detected.   4.3 inch LCD screen   The large and bright 4.3 inch LCD screen allows you to view current and saved recordings and makes the menu easy to access.  It has an optional screen saver that activates after 3 minutes so as not to distract the driver too much.   Supports memory cards up to 32 GB 32 GB stores approximately 4 to 6 hours of 1080p HD recordings   It has a 170° wide + 120° wide "fisheye" lens to make sure that the large area around the vehicle is visible and captured.   It has a built-in 450mAh small battery for safety reasons.  The battery makes sure that the current recording can be saved to the memory card in case of power loss.   Note that the battery is not intended to power the dashboard camera for a longer time, the battery has not enough capacity.  Therefore the camera must always be connected to a power source in order to function properly.   It contains the option to make images.  Photo mode can be accessed by holding the menu button longer and the photos are stored on the SD card in a separate folder.   When operated by cigarette power plug, it will automatically start recording when the car is turned on and will stop recording when the car is turned off.  Note that this function will only work on vehicles that supply power through the cigarette outlet when the ignition is on.  When power is also supplied when the ignition is off, it will remain on and must be manually turned on and off.   The camera's built-in G-sensor records when you have an accident and in this case saves the current file to a special emergency folder on the memory card.  Files in this folder cannot be erased by loop recording.   It contains a built-in microphone.  The microphone can be muted in the menu.   The current time and date of the recordings appears in the bottom corner of the videos.  This setting can also be turned off in the menu.